DODGE DAKOTA FORUM - FORUM AND OWNERS CLUB! - Reply to Topic
DODGE DAKOTA FORUM - FORUM AND OWNERS CLUB!  

Go Back   DODGE DAKOTA FORUM - FORUM AND OWNERS CLUB! > DODGE DAKOTA FORUM - Help Zone - Dodge Dakota Problems, Complaints, and Solutions > 1ST Generation Dodge Dakota: 1987 - 1996 > Dodge Dakota Heating & Cooling Problems & Questions > A/C Heater Control Assembly
Dodge Ram Dodge Durango Dodge Nitro Jeep
Diesel Forums!
Dodge Ram Forum Dodge Durango Forum Dodge Nitro Forum Jeep Forum
Dodge Challenger Dodge Charger Chrysler 300 Dodge Magnum
Dodge Caliber
Dodge Challenger Forum Dodge Charger Forum Chrysler 300 Forum Dodge Magnum Forum


Thread: A/C Heater Control Assembly Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the DODGE DAKOTA FORUM - FORUM AND OWNERS CLUB! forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address

Please enter a valid email address for yourself.

Note: If your email address requires someone to click a link before they can send you email, DO NOT REGISTER WITH IT as no one is here to click the link and you will never get your activation email!
We have banned MANY Free email providers.
If you get notice that your email address is banned when you try to sign up, it is because its been banned due to spammers using the provider, or too many members bouncing emails we send back to us via the free provider! If this happens to you, you will need to use a different email. If you do not provide a valid email address you will not receive your activation email. We recommend that you register with an email address which is attached to your ISP! Not a free service! We have found that using free accounts causes you to not receive your registration email. In any case, you should add DakotaForumZ.com to your spam filter whether using a free account or your ISP account. If you bounce email to us, you will have your account deleted and your IP address banned!

Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-27-2015 05:47 PM
davidro60 Thanks for the post. I wanted to close out this post by commenting that you were right and did more testing and the blower motor resistor was bad. Took it out after finding some resistance in the wiring to it and found it with one of the terminals that had corrosion. Replaced with a new one and now have heat.
12-25-2015 03:20 AM
RalphP Not that hard to find for the switch itself ... http://www.rockauto.com/catalog/rafr...&parttype=4248

But that fails so rarely, I'd be sitting with the multimeter and checking a) the wiring from behind there to the resistor, and b) did you ohm through the resistor? Also, did you check the connector resistance? Best thing is to check the voltage across the switch terminals when you have the blower "on". Also check the voltage across the fan connectors, make sure that you are, or aren't, getting power across the fan connector.

RwP
12-24-2015 07:51 PM
davidro60
A/C Heater Control Assembly

I have a 1994 Dodge Dakota 4x4 and last week the heater blower stopped working. I've tested the fuse block and the fuse in the distribution panel and have power and fuses are good. I have power to the blower motor. Also checked the fan resistor located on the firewall on the passenger side and all looks good and also has power. Today, I went ahead and tested the fan and works just fine. I did check the wires for the blower motor and the fan resistor using my ohm meter and no issues detected. I'm thinking it's the A/C Heater Control Assembly and need to know how one would test the electrical portion of the assembly. I'm thinking this part is going to be very hard to find.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


» Advertisement



All times are GMT. The time now is 02:13 AM.


Powered by vBulletin® Version 3.8.10 Beta 2
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
vB.Sponsors
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright © VerticalScope Inc. All rights reserved.