Dakota Forumz banner

1 - 5 of 5 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
The brakes have been less than stellar. What have you installed in place of the factory brakes? I have rotors in front and drums in the rear.
 

·
Registered
Joined
·
86 Posts
Just an FYI
If you run into issues with bleeding the brakes there are two types of proportioning valve which are prone to failure and the electronic one is hard to find.
I lucked out and found a good used one on EPay.
 

·
Registered
Joined
·
140 Posts
2699

here’s the new rotors and pads I just bought today. Being in Canada they were cheap as I got free shipping and no xtra duties! Finally! LOL. They need to be broken in properly to prevent warping so I won’t be putting them on until I get home from work in two weeks. Don’t trust the wife to do it properly! LOL. I bought these ones cuz they won’t rust and stay black and will match my truck. I bought blue calliper paint and heat safe dodge stickers as well. Gonna look sharp. Can’t remember who showed me on this site but that for the idea and can’t wait to get home and complete that part of my build. Few more items and Bertha will be done!
 

·
Registered
Joined
·
86 Posts
The stock rotors are known for warpage issues.
Good move going with aftermarket.
I used the grooved and drilled ones.
100,000 miles + on that set of rotors.
And I tow a lot.
 
1 - 5 of 5 Posts
Top