Dakota Forumz banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I just purchased a 2000 dakota 5.9 4x4 for my son. When purchased had codes 1762 and 1763. The previous owner replaced solenoid and transducer off of amazon. I purchased complete mopar kit with internal harness. Now i have code 748. Dropped pan again to recheck connections etc. Nothing found refilled and 748 comes up almost immediately. Before symptom was no 1st gear unless manually shifting into it? Now no 1st gear and no overdrive. Can still get 1st on manual shift? Swapped trans control relay with anther relay no change. Upper harness seems to be ok. The only other recommendations are replace pcm? An I missing anything? Thanks in advance!!!
 

·
Registered
Joined
·
47 Posts
Not sure what those codes are, but have you tried the governor pressure switch and solenoid? I had that happen in my 03 once. It was always trying to start out in 2nd pr 3rd gear. So you had to manually upshift. Downshifting was fine, just when youd get to a stoplight youd have to drop it down in 1st and start over.
 
1 - 2 of 2 Posts
Top