Dakota Forumz banner

1 - 4 of 4 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter #1
I recently got a code for a bad hall effect/pickup sensor after the truck left me stranded. Ive replaced the sensor and while I was trouble shooting for another problem I may have had I removed the battery leads. The truck is running now after all repairs but when I do the engine code check procedure (On and off ignition 3 times) its still showing me that the hall effect sensor is a problem and that the battery has recently been disconnected. Is there a way to reset the system?? Thanks in advance!
 

·
Registered
Joined
·
33 Posts
Discussion Starter #2
I figured it out. You have to disconnect the battery and hold the break for 30 seconds then connect it back up and drive the truck for 20ish minutes. Mine cleared right away without having to drive it around any.
 
1 - 4 of 4 Posts
Top