Dakota Forumz banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I cannot seem to find new or aftermarket Upper control armsystem for my 94 sport. Does anyone have any leads or suggestions? I warped mine pressing out the bushing sleeves
 

·
Registered
Joined
·
3 Posts
Upper control arm bolts for mounting and alignment are no longer available... Mine were rusted and stripped. After much searching... Solution: Ace Hardware Grade 8 bolts. 9/16" x 18 thread (fine) x 1/3/4". Replacement control arms for 97 and later have similar geometry but the ball joint is riveted on the end of the arm instead of pressed into it. Word has it that the ball joint shaft/bolt is a different size than the 87-96. good luck.
 
1 - 3 of 3 Posts
Top